1 / 1
Remixed Makita Trim Router to Track Saw Rail Adapter - Tight Tolerance with Guide Bushing Geometry — zdjęcie 1

Remixed Makita Trim Router to Track Saw Rail Adapter - Tight Tolerance with Guide Bushing Geometry

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remixed Makita Trim Router baseplate to adapt to a tracksaw guide rail, based on the adapter by @JohnMartin

Ocena
0 / 5
Polubienia
39
Pobrania
298
Wydruki
0
Wyświetlenia
1237
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the Tracksaw Guide plate/adapter for Makita Trim Router by @JohnMartin.  

This is still a work-in-progress, further fine tuning tolerances.

 

In this remix, I made the fit of the grooves for the track saw guide rail a bit tighter.

Included are both metric and imperial variations.  The imperial version has the distance between the track saw guide rail and the center of the bit set to 2" (50.8mm), rather than the original 50mm.

Also included are variations with and without guide bushing geometry.  I don't think you would ever use the track saw guide rail and a guide bushing at the same time, but to save from having to swap base plates back and forth, guide bushing variants were added at the cost of a bit more support material.

There were also a couple of cosmetic changes made, including widening the air duct ramp and shortening the centerline alignment tab.

---

8/3/25 Update - I found my original remix files to still be slightly looser than I'm looking for.  These were 0.011" (0.28mm) tighter than the originals.  I'm printing samples with 0.0115" (0.29mm) and 0.012" (0.30mm) tighter geometry where it fits on the track to test out.  The 0.011" is definitely usable as is, but I would probably recommend at least the 0.0115" variation for most well-tuned printers, or run test prints with only the track saw guide rail geometry to test fit before printing the full file.

I also split the different tolerance versions into folders which each have the Inch and Metric variations, with and without guide bushing geometry.  I'll likely reduce the number of files once I test these latest versions.

Tagi