1 / 7
Cooler Master HAF 912 - Top Fan Duct Cover — zdjęcie 1
1 / 7

Cooler Master HAF 912 - Top Fan Duct Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Orientacyjna cena wydruku pliku

14,66 € – 17,92 € netto (bez VAT)

Dla pliku: HAF Case Top Cover Fan Duct V2_0.3mm_PLA_MK3S_12h13m.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 16,29 € netto (środek widełek).

Masa podana przez autora
289 g
Czas druku podany przez autora
12,21 godz.
Materiał u źródła
PLA
Materiał wyceny
PLA
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Fan Duct Cover for the Top opening on the Cooler Master HAF 912 Case

Ocena
0 / 5
Polubienia
1
Pobrania
13
Wydruki
0
Wyświetlenia
168
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Standard Digital File License

These Files are Version 2.0 of the HAF Case Top Cover Fan Duct.  

This is a Fan Duct designed to cover the top opening of the HAF 912 Case.  This model has locator pins that use the watercooling holes.  If you want a version that uses other holes, contact me.  The model was designed to “just” fit within the Prusa MK3S Print Bed.  

For those of you that still run this beast of a case, you will understand what this is for.  The top mesh opening on the case is quite susceptible to dust, debris, etc.  I originally thought to remove the top fan and block off the top mesh. Then, I thought about designing a fan duct cover. Is it airflow efficient? Most likely not.  I'd rather have a fan at the top pulling air in with this 3D printed duct then fully blocking it off.  There is also the argument of wanting to use as much of the Prusa MK3S print bed as possible.

As for printing the beast, the Version 1.0 files I landed on 0.30 Layer height, with 8% gyroid infill and no changes to perimeters.  The print is quite durable and holds up well enough.  I redesigned it and created the Version 2.0 files.  It has a bit more of the HAF design and less duct wall coverage to allow more airflow.

- Layer Height: 0.30 (Used the Draft 0.30 profile for the MK3S)
- Infill Density: 8% to 12%
- Infill Pattern: Gyroid
- Textured PEI Sheet for the textured finish (Plate finish is your choice, make sure to adjust for warping)

Disclaimer: The photo gallery showcases the Version 1.0 of the design.  

Tagi