1 / 6
Creality SpacePi Space Pi X4 X4L Heat Shield Deflector — zdjęcie 1
1 / 6

Creality SpacePi Space Pi X4 X4L Heat Shield Deflector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Heat shield for the Creality Space Pi X4 & X4L to keep hot air from blowing directly onto filament spools while drying.

Ocena
5 / 5
Polubienia
154
Pobrania
720
Wydruki
25
Wyświetlenia
3404
Oceny
22

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

A heat shield designed to stop hot air in the Creality Space Pi X4 and X4L from blowing directly onto the filament spools while drying.

I found DJR Engineering's heat shield on Makerworld. It was too flimsy for me, though. So I designed my own from scratch. But I was inspired by him, though ;)

I'm offering two versions here: one standard and one with a cutout for my filament spool guide.

The heat shield is easily attached with two M3x10 screws. These are simply inserted to anchor the shield. You can also use screws that cut slightly into the plastic mesh. These should be 3,5mm or 4mm thick. The holes in the shield can easily be drilled to the desired size.

Printing Settings:

  • Material: ASA, NYLON, PC

  • 0.2mm Layer high

  • 3 perimeters

  • 25% Infill

  • Use a big Brim (Outside and inside)

I also recommend installing my filament spool guide. This must be clipped in first. Only then can the heat shield be inserted.

Tagi