50mm Fan Bracket For LSI 92xx SAS HBA PCIE Card
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 50mm fan bracket to suit LSI-9211-8i or similiar SAS HBA PCIE Card for more airflow - these chips run hot!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a bracket to mount a 50mm PWM fan to the heatsink of an LSI 92xx SAS HBA card (LSI-9211-8i shown). May not fit all variants of this card as there are several variations on the heatsink shape and card layout.
The bracket slides down over the top of the heatsink and grips underneath clearing all the SMD components. Cutouts allow clearance over the status / UART connector near the heatsink, and for fan cable management.
As for expected performance, it depends on your 50mm fan, system load and general case/chassis airflow. Before install the onboard die temperatures hover around 70° - 80°C, peaking around 90°C under heavy load. After install, running constant PWM fan speed of 60% there was reduction to 55° - 65°C average with peaks around 75°C.
Recomended print settings:
Material: PETG, HT-PLA, ASA (Standard PLA will deform at operating temperature)
Wall Layers: x4
Top/Bottom Layers: x4
Infill: Gyroid/TPMS-D at 20%
Supports: Tree
Best print orientation is face with cutouts toward build plate.