Easy Rev 2 EX BCAR Adapter +Streamlined Front Sight --> Volcanic Pro * Dart Zone

--> Update
---------------

Easy Rev 2 EX BCAR Adapter
+ Streamlined Low Profile Front Sight
Dart Zone Volcanic Pro

Easy plug-in adapter for the EX BCAR Rev 2 to be easily attached to the Volcanic Pro.
Works with the stock barrel and muzzle of the blaster!

Slide on Picatinny mounted and streamlined clearly visible and zeroed low profile front sight for improved aiming in combination with the stock rear sight.

I didn't really like the front of the Volcanic Pro with the stock Dart Zone BCAR, so I looked for a simple and more compact alternative.

The blaster is about 5cm shorter and in my opinion, it looks much better  this way.
Thanks to the EX BCAR, it still shoots very accurately.
(I'm using the 8dot5 Classic EX BCAR2 for my Volcanic with stock spring)

--> I recommend lightly sanding the inside of the adapter with fine sandpaper.

--> If the adapter is not firmly seated in the muzzle due to printer tolerances, simply wrap a bit of of teflon tape around it to increase friction.

• Update 20.12.2025:
  Optimized the shape of the funnel in the adapter and the shaft was lengthened slightly so that it reaches all the way to the rear stop of the muzzle.
  

------------------------------------------------------------------------------------------------------------------------

The files are already pre-oriented.

My print settings for PLA:

0,2mm layer height
4-5 walls
20% gyroid infill
7 top and bottom shell layers
(print with outer brims if you have poor print bed adhesion)
NO supports needed

Thanks to Epicxxxx for the files I could use for this remix.