Coin Engraver Fume Extractor – 4" Window Vent System (3D Printable)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Coin Engraver Fume Extractor
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 119
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Standard Digital File License
using a standard 4-inch vent hose, keeping your shop air clean and your laser optics clearer during engraving and marking jobs.
Optimized for engravers using standard fiber laser beds, this low-profile extractor is ideal for coin engraving, flat parts, and short-height projects where a full enclosure or bulky extractor isn’t practical.
The design mounts directly to common laser bed rail patterns and channels fumes efficiently outside—helping improve engraving quality and visibility while you work.
Included Files
3MF – print-ready, pre-oriented, minimal setup required
STL – for custom slicer profiles and adjustments
Mounting brackets with 6.5 mm holes, 25 mm on-center spacing
Key Features
Fast, direct ventilation – pulls smoke and odors straight outdoors
Compact footprint – ideal for low-profile engraving jobs
Broad compatibility – fits most standard laser beds (verify hole spacing)
Simple install – aligns with common rail patterns and standard window vents
Specs & Fit
Vent interface: 4-inch hose (standard dryer / vent hose)
Mounting pattern: 6.5 mm holes, 25 mm on center
Print Notes
Material: PLA
Infill: 15%
Supports: Tree supports recommended
Tip: Slice the model in half to reduce support material, or use the included print-ready 3MF to skip guesswork
How to Use
Mount the brackets to your laser bed
Attach the extractor body and connect a 4" vent hose to your window vent
Run a quick smoke test to confirm positive airflow outdoors
🔒 License & Commercial Use
Personal use license included
No sharing, reselling, or redistribution of files or printed parts
👉 Commercial rights available only via Workshop Pro (Tier 2)
Commercial permission ends immediately if membership is canceled or downgraded.
All designs remain the property of Song Dawg Designs.
🔗 Support
https://songdawgdesigns.com/shop
Patreon
https://www.patreon.com/c/SongDawgDesigns
Etsy (Physical Products & Shop):
https://songdawgdesigns.etsy.com
3D printing settings
Material: PLA
Infill: 15%
Supports: Tree supports recommended
Tip: Slice the model in half to reduce support material, or use the included print-ready 3MF to skip guesswork