IKEA VIDGA Aqara E1 Curtain Driver Mount - Slide-In, No Glider Removal (204.830.02)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two identical parts connect into a stable, smooth-gliding Aqara E1 mount for IKEA VIDGA rails. No gliders to remove.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
Check my other IKEA designs:
Mount for the Aqara Curtain Driver E1 (Track Version, CM-M01) on IKEA VIDGA rails.
Why this one
Glides really smoothly. The two parts connect to each other, so the Aqara stays stable on the rail.
You don't have to take down the curtain or remove any gliders
No screws, no bearings, no tools
Print two identical parts. One STL is all you need.
Takes the place of two gliders from the VIDGA "Glider and hook" set (204.830.02)
Installation
Slide the first part into the rail slot.
Slide the second part in right next to it.
Align the two parts.
Hang the Aqara E1 on the mount.
Compatible with:
VIDGA single track rail – 204.929.16
VIDGA single track set – 494.282.32
VIDGA curtain track set for ceiling, 2 tracks – 495.715.07
VIDGA two track set – 294.282.66
Not compatible with the E1 Rod Version.
Material and print settings
Use the most slippery filament you can print with. Listed from easiest to hardest to print:
PETG – tested. Easy to print and glides well.
ASA / ABS – untested. Handles heat better, but needs an enclosure.
Low-friction "tribo" filaments (e.g. igus iglidur) – untested. Specs look great but expensive.
Nylon (PA) – tested. The most slippery option, but dry the filament first and expect higher print temperatures and warping.
Not recommended: PLA. It softens in the heat behind a sunny window and wears faster.
Wall loops: 3–4
Infill: I printed with 40% but didn't test other settings
Quantity: 2 identical parts
Tips
A little silicone lubricant in the rail makes gliding even smoother.
Skip oil-based sprays like WD-40, because they collect dust.
Check that the rail sections are aligned and the joints between them are smooth. If a cut end is rough, sand it.