Ubiquiti UNAS Pro + USW-Pro-24-PoE Shelf Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a two-piece shelf stand for stacking a 1U USW-Pro-24-PoE above a 2U UNAS Pro. May work with other 1U->2U stacks.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a two-piece shelf stand for stacking rack mount networking gear. This build was done specifically for Ubiquiti USW-Pro-24-PoE above a UNAS Pro while leaving approximately 12.6 mm of open ventilation space between the UNAS chassis and the underside of the switch supports. It may fit other 1U-over-2U combinations, but equipment-side rack-ear screw patterns are model-specific. Compatibility beyond the two listed Ubiquiti models has not been verified.
The design uses the factory rack-ear screw holes and screws. It is intended for installation on a shelf that directly supports the UNAS Pro and both printed brackets.
Remix attribution: This is a remix of Unifi Desktop Server Rack Mount by DDD Projects / @D3Dorsett.
Tested with
Ubiquiti UNAS Pro
Ubiquiti USW-Pro-24-PoE
Factory rack-ear screws
Bambu Lab X1 Carbon
PAHT-CF filament
Compatibility with other devices has not been verified.
Printing
Print one left bracket and one right bracket
Use the supplied orientation
Do not scale the models
Supports: off
A 5 mm brim worked successfully with PAHT-CF
Dry nylon-based filament before printing
Printing the brackets separately reduces the consequence of a lifted corner
Assembly
Remove the factory rack ears and any rubber feet that would change the chassis height.
Place the brackets and UNAS Pro directly on the same level shelf.
Start all UNAS screws loosely before tightening them.
Place the switch on the four upper support pads.
Start all switch screws loosely before tightening them.
Confirm that all four switch supports make contact.
Install drives and apply the final load only after checking the empty fit.
This is an independent community remix and is not an official Ubiquiti accessory.