2cm condiut bung for pulling with hook and magnet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
works with 2cm condiut goes in the end. The hook and magnet make it easier to locate the conduit in the wall
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 188
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
V1 is desighned to print without suports on its side as shown in the renders.
V2.1 onwards requires supports to print but not verry many if you use a tree suport configeration.
The magnets go in to the hole you can see at the bottom of the bung it is desighned to fit 3 6mm-3mm neodymium magnets however they will need to be glued as i have made the whole 0.5mm bigger than required to make it possible to glue them becuase heat pressing in that many magnets sounded like a recipie for disaster.
In adition V2.3 has a notch in the hook to make it harder for a rope to fall of. And a shaped end to make it easeir to fit.
If you have problems with it staying on cut the condiut down its length and then zip tie untill tight to reduce size of conduit then to remove cut of conduit and cut zip ties.