SV06 Plus Fan Duct Regular Volcano
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use regular Volcano Nozzles!!
- Ocena
- 4 / 5
- Polubienia
- 108
- Pobrania
- 717
- Wydruki
- 6
- Wyświetlenia
- 6422
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
…Please at least be sure to hit like & post a make, I'd love to see your prints!
Use volcano nozzles in your sv06 plus.
DONT LEAVE A BAD REVIEW BECAUSE YOU DID A BAD PRINT! Like the single reviewer here! That's just not cool.
It’s basically just meant to be a quick & simple no-frills stock unit replacement to allow you to install & use regular volcano nozzles. It’s meant to just get you printing with the new nozzle type, please don’t expect upgrade miracles.
Print standing upright on its flat nozzle-side face. Use petg 0.2-0.3mm layer height. No supports required.
Once printed. Replace stock fan duct
Add volcano nozzle, fit silicone sock after slightly trimming back the height of the nozzle opening - not too much!!
You will need to adjust the probe in the holder upwards to set your new Z offset correctly - check YouTube for setting inductive probe height.