1 / 24
Delta 713Maker Aluminum Rostock Effector Plate 3010 Part Cooling Blower Mount for Kossel — zdjęcie 1
1 / 24

Delta 713Maker Aluminum Rostock Effector Plate 3010 Part Cooling Blower Mount for Kossel

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A part cooling fan mount and nozzle for the 713Maker Rostock ball cup effector plate using a 3010 blower.

Ocena
5 / 5
Polubienia
3
Pobrania
32
Wydruki
1
Wyświetlenia
588
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A part cooling fan mount and nozzle for the 713Maker ball cup effector plate using a 3010 blower.

I am rebuilding my old MakerLibre 1515 Mini Kossel and upgrading it along the way. I decided to go with the SeeMeCNC ball-joint effector arms and the aluminum plate from 713Maker along with their E3D V6 threaded heatsink mount kit. I first built this printer almost 10 years ago and this is the first time it's had a part cooling fan. I didn't find anything online that I liked or that was slim and did not protrude beyond the aluminum effector. I have roughly 7mm of clearance below the effector plate to the nozzle, and I need every bit to clear the small binder clips that hold the glass plate to the heat-bed. So far this is working great with just two fans (a third will be added later) and I didn't lose any printable area.

 

4/17/2023 Update: modified the 3010 blower mount with a cut-out to aid intake air flow and removed the countersink. File name is “effector_fan_mount_6.7.2”

These work ok; there is not much room on this type of delta effector and I didn't want to lose print area/increase effector diameter, so this setup is better than nothing. The nozzles would definitely print and work much better if they were resin printed, which I will do when I get the time.

7/5/2023 - New pictures showing resin printed part cooling nozzles, which work much better than the FDM printed nozzles. I highly recommend resin printing the nozzles; the top fan mount part is fine FDM printed. The grey nozzles are resin printed, the white are FDM printed.

Print three of each part; the blower nozzle needs to be printed with supports while the larger fan mount could use supports for the counter-bored screw hole. I designed these to have a 0.9mm wall. My print settings with a 0.4 nozzle are:

0.45 line width, 2 walls, first layer @ 0.2mm, the rest @ 0.1mm for 1.0mm top & bottom, 20% cubic infill, 40mm/s speed.

 

Parts / Hardware Needed:

6x M3x12 screw

3x M3 nut

3x M3x6 low profile screw (screws from bottom of effector)

3x M3x9mm diam. flat washer (for top hot-end mount)

3x 30mm x 10mm blower fan

 

If you like my designs and want to send me a tip, you can do so via PayPal….. Thank you and enjoy the models I create.

Tagi