Delta 713Maker Aluminum Rostock Effector Plate 3010 Part Cooling Blower Mount for Kossel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A part cooling fan mount and nozzle for the 713Maker Rostock ball cup effector plate using a 3010 blower.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 32
- Makes
- 1
- Views
- 588
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A part cooling fan mount and nozzle for the 713Maker ball cup effector plate using a 3010 blower.
I am rebuilding my old MakerLibre 1515 Mini Kossel and upgrading it along the way. I decided to go with the SeeMeCNC ball-joint effector arms and the aluminum plate from 713Maker along with their E3D V6 threaded heatsink mount kit. I first built this printer almost 10 years ago and this is the first time it's had a part cooling fan. I didn't find anything online that I liked or that was slim and did not protrude beyond the aluminum effector. I have roughly 7mm of clearance below the effector plate to the nozzle, and I need every bit to clear the small binder clips that hold the glass plate to the heat-bed. So far this is working great with just two fans (a third will be added later) and I didn't lose any printable area.
4/17/2023 Update: modified the 3010 blower mount with a cut-out to aid intake air flow and removed the countersink. File name is “effector_fan_mount_6.7.2”
These work ok; there is not much room on this type of delta effector and I didn't want to lose print area/increase effector diameter, so this setup is better than nothing. The nozzles would definitely print and work much better if they were resin printed, which I will do when I get the time.
7/5/2023 - New pictures showing resin printed part cooling nozzles, which work much better than the FDM printed nozzles. I highly recommend resin printing the nozzles; the top fan mount part is fine FDM printed. The grey nozzles are resin printed, the white are FDM printed.
Print three of each part; the blower nozzle needs to be printed with supports while the larger fan mount could use supports for the counter-bored screw hole. I designed these to have a 0.9mm wall. My print settings with a 0.4 nozzle are:
0.45 line width, 2 walls, first layer @ 0.2mm, the rest @ 0.1mm for 1.0mm top & bottom, 20% cubic infill, 40mm/s speed.
Parts / Hardware Needed:
6x M3x12 screw
3x M3 nut
3x M3x6 low profile screw (screws from bottom of effector)
3x M3x9mm diam. flat washer (for top hot-end mount)
3x 30mm x 10mm blower fan
If you like my designs and want to send me a tip, you can do so via PayPal….. Thank you and enjoy the models I create.