1 / 9
62mm Lens Cap Holder / Camera / Clip / Olympus Hotshoe
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
4 Versions possible / 0.6 nozzle possible / 0,18 layer hight / 18g only / Not in your mouth, in your third hand!!!
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
My settings: 0.6 nozzle with 0.18 layer height.
Support under clip, tree.
Seam offset.
Piece of filament as connection. Melt the ends with a lighter and press a little against the end.
Screw the screw firmly into the plate. Only then install it on the camera.
Everything at your own risk!
I hope you like my design and you'll leave a like or make! 😀
Happy printing!!!