Eagle Eye 22mm Dual LED Light Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple mount for 2x 22mm sized "Eagle Eye" LED lights. Designed for use on a mountain board as tail lights.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 215
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is for mounting 2x “Eagle Eye” 22mm diameter LED lights. I designed this for mounting 2x red lights to the rear of my SYL-08 board to act as tail lights. Uses 2x #6x1/2" screws for mounting. Printed mine in Polycarbonate, but PLA is fine as these Red LEDs don't go above ~50°C ambient.
These Eagle Eye LEDs can be found everywhere from Amazon to AliExpress.
Print Settings:
Print on its side with supports on the overhang side of the middle support. A brim is recommended for bed adhesion due to the high aspect ratio of the part.
Reference the image below;
NOTE: The red 3D printed fan blades connected to my motors, collide with this light mount when turning sharply. I ended up removing them as my motors weren't getting very hot, but I may redesign this mount eventually to accommodate them.