Eagle Eye 22mm Dual LED Light Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple mount for 2x 22mm sized "Eagle Eye" LED lights. Designed for use on a mountain board as tail lights.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 215
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is for mounting 2x “Eagle Eye” 22mm diameter LED lights. I designed this for mounting 2x red lights to the rear of my SYL-08 board to act as tail lights. Uses 2x #6x1/2" screws for mounting. Printed mine in Polycarbonate, but PLA is fine as these Red LEDs don't go above ~50°C ambient.
These Eagle Eye LEDs can be found everywhere from Amazon to AliExpress.
Print Settings:
Print on its side with supports on the overhang side of the middle support. A brim is recommended for bed adhesion due to the high aspect ratio of the part.
Reference the image below;
NOTE: The red 3D printed fan blades connected to my motors, collide with this light mount when turning sharply. I ended up removing them as my motors weren't getting very hot, but I may redesign this mount eventually to accommodate them.