Liczymy pasujące modele…
This is a wall-mounting bracket to be used with the smaller F1 Speed Champions Lego sets. It can be printed without supports (big, flat side down) and features a 4mm countersunk hole for attaching. Print pictured used the following…
This is a wall-mounting bracket to be used with the smaller F1 Speed Champions Lego sets. This one has the car nose pointing down for a better view of the cars themselves. If you don't have a 3D printer (I know, odd place to mention…
Updates These are the changes I made to the instructions: I changed the part numbering to match the part splits. I added some steps for the new parts needing glued together and pushing out the deliberate support in the mouth of the body.…
This is a modular hexagon display system for test printing benchy models that can be displayed. If you squint a little, you can also use these models as a way to verify your print tolerances. The stand base can be used on the bottom-most…
I printed a bunch of eric-ao's safety locks for my own drawers but ran into a few cases where the gap I had was just too narrow. Simply height adjustments to make it fit in some tighter spaces more easily. Printed at .2mm layer height in…
A simple bottle koozie for 12 fl oz (350ml) bottles. The inside is ribbed to allow for some minor expansion to hold the bottle tightly. This also can work with 12 fl oz cans like the narrow seltzer cans, but doesn't hold them as tightly.…
I wasn't satisfied with some of the models online, so I tried my own hand at it. The O's can be chained together as many times as you want. Longer chains might need a nail or something to support it in the middle. There are two different…
Print Settings (Should be in 3mf project file): Material: PETG - PLA will stress fracture over time and PETG hinges more nicely Layer Ht: 0.3 mm Perimeters: 3 Top Solid Layers: 6 - Helps with waviness from the default 4, purely aesthetic…
Based off @gleonard3's Pixel 10/10 Pro case to add a small pocket to use a set of magnets and a body that can be used as a modifier to add top/bottom layers to the pocket so the magnets don't slip out. This model is intended to be printed…
There are a ton of other dog waste bag roll dispensers on Printables, but I couldn't find one that had a tab on the exit of the tube that will automatically tear off the bag. I had another bag dispenser like this, but it finally bit the…
Simple wall-mount bracket for 1:43 scale Bburago models. Counterbored holes are intended for ~2mm wire nails.
I wanted to get my Scarlett Solo off of my desk to clear up some space. This ties into my monitor's VESA mounts and then holds it just below the bottom bezel. The model doesn't require any supports. It has a pin that was intended to keep…
Overview This is a benchy display stand similar my original remix, with tighter tolerances. This version changes a portion of the back into a flat panel, making it perfect for adding labels of the filaments. It is compatible with the old…
Last Meter Brick - Remix This is a remix of Quinlan's Last Meter Bricks. I've added the STEP file that I recreated the brick from. Each building block takes ~one meter or less of filament to print depending on settings. The blocks snap…
A simple clip which a 8mm width COB light strip can be pushed into or slide over before soldering. It has a pocket at the bottom for an 8x3mm magnet to be glued into. Print Parameters: 3 perimeters 0.2mm layer height Infill doesn't matter
This is a sliding scale mood meter with 5 emotive faces on it. There are intentionally no labels for the faces, allowing people to apply their own definition to suit their needs. It could be mood: Dead, Sad/Sleepy, "Meh", Happy, or…
To wszystkie aktualnie dostępne wyniki.
