Liczymy pasujące modele…
Introduction This project consists of 3 differently sized collapsible crates - all use the same wall thickness and stack perfectly on top of each other - 2x "Half" fits on top of 1x "Full", 2x "Quarter" fit on top of 1x "Half", similarly…
General This design is a combination of a nozzle wiper and a purge bin. The nozzle wiper is a remix of the design by AmethystZhou, which I have not modified by much. I replaced some chamfers with fillets, as I prefer the look of those…
The bottom part should be printed flat without supports, mid and lid parts flat with supports enabled. These need good bed adhesion, as the outer "ring" that will be printed first tends to warp up and disconnect from the bed as the print…
Most MX-Style switch openers are printed vertically, resulting in low stability of the "tips" which have to pry the switch legs open. This model has been designed to be printed flat in two pieces (both are identical, so print the file…
The Cornholius wireless keyboard project started as a bluetooth drop-in replacement PCB for the Foostan Cornelius ergonomic custom keyboard. PCB sources and files to order both a fully assembled PCB as well as a FR4 switch plate can be…
The original armrests on the Markus were not particularly comfortable for me and simply omitting them left me with ugly bolt holes and a hard-to-carry chair. These handles fixed both problems. You can use the original bolts or, if you…
Some Ikea Markus batches seem to have the backrest mounting plate at a slight angle - this results in a slightly laid back position of the backrest even in the most upright setting. This wedge adds 4° of inclination to the backrest,…
These drying trays use a weaved design I have first seen in this model by Kie . This allows for very fast printing of meshed sidewalls with nearly zero retractions. A very elegant design that I copied for this model. I designed it for…
I designed these models to make it easier to fill HOLY or similar water-flavoring powders into drink bottles. The Sodastream funnel model should fit most Sodastream bottles, but I have no idea how standardized flip-top bottle neck sizes…
This is a simple flower planter. It consists of two parts, the actual planter and a driptray, which slide into each other. The slanted seam between the two parts acts as a design element. The planter is not touching the bottom of the…
I designed this screwdriver for a friend who lost the one supplied with the toy firetruck on the pictures. It is printed in two parts that are snapped together. Depending on your printers tolerances and filament choice, this might need a…
This is a simple lens hood for Sigma C 45mm f/2.8. The round one is aimed at a similar length as the original Sigma lens hood (I do not have it so I could not take measurements), while the other model is designed to resemble traditional…
To wszystkie aktualnie dostępne wyniki.
