Liczymy pasujące modele…
10" Rack tray to hold a Dell Optiplex 5070 (although other Optiplex models should fit) but also with an option to add a keystone jack (see my other models if you want to test print the same port to test). ** NOTE: These Rack components…
Designed to suit my own needs alongside other models I've uploaded on Printables ** NOTE: These Rack components were designed to fit a HOME MADE rack using rack rails and my supports to build a home made rack, therefore they may not fit…
Broke clip that holds the rubber mount for the parcel shelf so knocked up a replacement that seems to hold up well. I had a bit of stringing with my PLA which has sat for a few weeks in a cold room so could be wet. Printed in PLA and…
I've a few Raspberry Pi's and SSD that I have on my desk, but was fed up of them being loose and sat on top of each other so a quick design later and I have a solution, I actually don't even need the screws to hold the SSD (which in turn…
Designed to suit my own needs alongside other models I've uploaded on Printables ** NOTE: These Rack components were designed to fit a HOME MADE rack using rack rails and my supports to build a home made rack, therefore they may not fit…
Designed to suit my own needs alongside other models I've uploaded on Printables ** NOTE: These Rack components were designed to fit a HOME MADE rack using rack rails and my supports to build a home made rack, therefore they may not fit…
Designed to suit my own needs alongside other models I've uploaded on Printables ** NOTE: These Rack components were designed to fit a HOME MADE rack using rack rails and my supports to build a home made rack, therefore they may not fit…
Made a model to organise network cables on my desk whilst seating my USW-LITE-8-POE on top of them. My 1st attempt at a full model to fit an actual device, so very much a version 1. What's wrong with it (being picky): The cable entry port…
Building my own homelab and just purchased the rack rails to 3d print my own components - Created these side braces to make a rack that is a little over 250mm deep to sit on my desk. I've fastened these to the rails with M5 bolts, a small…
I wanted an adapter to suit the Garmin R10 Launch Monitor stand from @mcfada So I designed one to fit in the hole that the stick would normally use, this should suit any small laser pointer from your favourite online marketplace. I got…
Found my CoreOne vent would sometimes shake closed (yes I could have tightened the vent a little) so decided I'd make something to keep it open - My other challenge is I switch between PLA and PETG quite often so I wanted to have…
I've created these leg extensions for the R10 Launch Monitor Stand as one of my local ranges uses a Mat within a frame so stands higher than most - These extensions give you a little more height to ensure that R10 sit correctly and…
To wszystkie aktualnie dostępne wyniki.
