Vent cover handle for Prusa CORE One MMU enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replace the wobbly/cheap knobs by a stylish handle and get the nuts out of the PTFE tube's way.
- Rating
- 5 / 5
- Likes
- 29
- Downloads
- 80
- Makes
- 2
- Views
- 468
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
The vent cover that comes with the stock MMU kit for the CORE One has two issues that this mod fixes:
The nuts protrude into the printing chamber and get into the way of the PTFE tube. Sometimes they open/close the vent.
The cover knobs look and feel cheap.
The first issue is fixed by installing heatset inserts into the holes of the stock vent cover. Use inserts not larger than 3mm to get a flush surface.
This model contains a stylish handlebar with screwholes matching the inserts, fixing the second issue. The stock rubber bands are reused to provide some friction control by tightening the screws. Use screws with threads not longer than 7mm, otherwise they will protrude into the printing chamber.
A parametrized Fusion360 is attached so you can adjust for different screw sizes, handlebar dimensions, etc. Or let me know what you need.
Printing
The model was designed for PETG with rather tight tolerances (to keep the model small). There is no reason it shouldn't work with other filaments too. Try a XY Compensation (Prusa Slicer) of -0.15mm if tolerances are too tight.
I used 0.15mm layer hight and low printing speeds to minimize visual artefacts. The model should be printable at greater speeds and layer heights too.
No supports are required when printed upside down.
Material
2x M2x6mm screw (with head diameter < 4mm)
2x 5x1.25mm rubber ring (reuse the ones that come with the stock enclosure)
It is important that the inserts are not longer than 3mm, otherwise the protrude into the printing chamber and get in the way of the PTFE tube. If you have M3 inserts that are short enough, they should work well (but you'll need to adjust the screw parameters in the fusion file).
Assembly
Disassemble the stock enclosure vent cover. Keep the rubber rings and the cover.
Install the heatset inserts into the cover holes (using a soldering iron and insert adapter).
Place the rubber rings into the bottom of the handlebar.
Insert the screws and attach the handlebar to the cover through the slits in the enclosure top.
Tighten or loosen screws to achieve the desired resistance.