1 / 1
PC Exhaust Duct — 90° Magnetic Fan Duct for 80/92mm Case Fans — image 1

PC Exhaust Duct — 90° Magnetic Fan Duct for 80/92mm Case Fans

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A 90° exhaust duct that magnetically mounts to your PC case's rear exhaust port, redirecting hot air

Rating
0 / 5
Likes
12
Downloads
62
Makes
0
Views
366
Reviews
0

Updated at source:

Model information

Category
Computers
License
GNU General Public License v2.0

Description

A smooth 90° exhaust duct designed to redirect airflow from a rear-mounted PC case fan. I needed a way to route hot exhaust air away from the back of my PC, and couldn't find a duct with the right profile, so I designed one in Autodesk Inventor. The duct features a quarter-circle curved interior that guides air through a gentle 90° turn with minimal pressure drop — much better than a sharp elbow. The exit opening is sized at 3.48" × 1.85" (internal), which preserves roughly 68% of the fan's circular intake area, keeping backpressure low enough that your fan won't struggle. Mounts magnetically to your case's steel rear exhaust port — just press-fit four 8mm neodymium magnets into the corner pockets and it snaps right on. No screws, no modification to your case, and easy to remove for cleaning or repositioning.

Specs

  • Fan compatibility: 80mm / 92mm

  • Fan-to-exhaust-port distance: 1.50"

  • Duct depth: 2.00"

  • Exit opening (internal): 3.48" × 1.85"

  • Magnet pockets: 4× Ø0.31" (fits 8mm diameter neodymium disc magnets, not included)

  • Pocket spacing: 3.17" center-to-center

  • Wall thickness: ~0.075" (1.9mm)

Print Settings

  • Material: PETG recommended (heat resistant near GPU exhaust). PLA works if your exhaust temps stay under ~50°C.

  • Orientation: Print as shown in the render — circular intake facing outward, flat back on the build plate. The part is small enough for most beds in this orientation.

  • Supports: Tree supports recommended. They'll handle the circular opening overhang and interior curve cleanly and break away easily.

  • Layer height: 0.2mm works fine. The interior stair-stepping from the curve is negligible at PC fan airflow speeds.

  • Infill: 15–20% is plenty. This part isn't structural.

  • Walls/perimeters: 3 minimum, given the thin wall thickness.

Notes

  • The magnet pockets are sized for standard 8mm diameter neodymium disc magnets — press-fit. If yours are loose, a dab of super glue will hold them in place.

  • Make sure all four magnets face the same polarity outward so they attract to the steel panel.

  • The design is parametric — if you need a shallower duct (less depth behind your case), you can reduce the 2.00" dimension, but going below 1.5" will noticeably increase backpressure on the fan.

Tags