Schlage Connect BE469ZP smart lock 3-7/8" deadbolt adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lengthen the deadbolt on the Schlage Connect BE469ZP smart lock to fit your 3-7/8"-sized door
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 35
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- BSD License
The Schlage Connect BE469ZP smart lock includes a deadbolt that supports 1-3/8" and 2-3/4" sizes. If you have a 3-7/8" deadbolt on your door, you are out of luck: this lock will not fit your door, and it's impossible to find a deadbolt this length with a mating pattern that supports the lock movement.
Unless you have a 3D printer! This adapter extends the deadbolt mechanism so that the body and the deadbolt arm reaches the 3-7/8" length, and the rest of the lock works perfectly. The carbon steel strengthening rod also stays in the area where it should be to ensure that the deadbolt is hard to cut.
To install, you'll need to disassemble the deadbolt first. There is a small, flat spring at the end of the mechanism: remove this by pressing one end downward and sliding it to the side. Also remove the pivoting arm that this spring holds. Then, twist the deadbolt and observe that there is a small nub that follows a channel that changes the size of the mechanism. Take a small flat head screwdriver and pry the nub downward until it can clear the channel, and pull the mechanism apart into two pieces. Lastly, you'll find a pin attached to the side of the deadbolt. Pick this pin out with your screwdriver, and the deadbolt will be removed along with the carbon steel rod (which will now be loose).
Print the parts in this model, and fit an M3 heat set insert into the small side of the deadbolt arm extension. It's designed for an M3x4x4.5 insert, but it'll take an M3x5x4 insert just fine. Slide this part into the deadbolt arm, then use a M3x6 screw to hold it in place with the arm extension cap. Place the carbon steel rod into the end of the arm extension, then fit the deadbolt over the arm extension with the rod inside. Line up the deadbolt pin hole on the extension and the deadbolt, then install the deadbolt pin. Put the deadbolt and the arm aside.
Then, fit the deadbolt body extender to the deadbolt mechanism and align the body extender's nub to fit in the channel. Place the pivoting arm back into the mechanism, and slide the deadbolt with the arm into place. Ensure that it mates with the pivoting arm correctly. Slide the deadbolt latch over the body extender, and have the nub of the latch housing follow the cutout on the extender (which twists to lock in place). Reinstall the pivoting arm spring.
And just like that, your Schlage Connect BE469ZP smart lock now works with your 3-7/8" door!