Extended battery cover and bumper case for Waveshare ESP32-S3 1.8inch amoled
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extended battery cover and bumper case
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 26
- Makes
- 0
- Views
- 155
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Welcome, my conventional non-conventional visitors! (RIP Tim Curry <3)
Here's my 3D-printable mod to fit a larger battery pack into this Waveshare kit.
It reuses the stock screws to secure the board and route the connector into the secondary snap-fit compartment.
I also threw in a bumper-style case/cover.
You might need to scale it slightly (around ~1%) depending on your printer's tolerances. You can just print the first 3–4 layers to check the fit, or just go for it - the whole print takes under 30 minutes with no special settings required. Personally, on my trusty old Prusa, I didn't even need supports for the bumper clip. Feedback and critiques are welcome.
Enjoy and happy printing! If you like this model, please leave a like and a comment with your makes.
That's all, folks!
Liked my model? Buy me a coffee or a beer to fuel my late night work on the next one!
