VW Golf 5 Headliner Repair Frame for Interior Light – 2-Piece (fits smaller beds)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two identical halves with lap joint and locating pins – fits beds from ~210 × 180 mm. Print in ASA, not PLA.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 16
- Makes
- 0
- Views
- 67
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
Two-piece version of Chissi92's headliner repair frame for the interior (dome) light of the VW Golf Mk5 (original: https://www.thingiverse.com/thing:6309638).
MATERIAL: ASA (or ABS) – NOT PLA
The headliner sits right under the metal roof and gets hotter than 70 °C in summer. PLA/PLA+ softens at around 55–60 °C and gives way under the pressure of the light. PETG is borderline.
PRINT SETTINGS (tested with ASA on an Elegoo Centauri Carbon 2)
- 0.4 mm nozzle, 0.2 mm layers
- 4 walls, 6 top / 3 bottom layers, 35 % infill
- Nozzle 250 °C (first layer 255 °C), bed 90–100 °C
- Fan 0–20 %, enclosure recommended
- 10 mm brim (outer + inner) against warping
- No supports. Flat side on the bed, joint and pins facing up.
- About 37 g and 1 h 20 min per half
- Printing the halves one at a time was the most reliable for me. The 3mf with both parts needs at least 256 × 256 mm.
ASSEMBLY
Print the half twice, flip one over and lay the joints on top of each other so the pins go into the holes. The halves click into place and sit flush.
INSTALLATION
The frame is clamped between the light and the headliner and pushes a sagging headliner back up. The light holds the frame, so no glue on the headliner. The light's spring clips still engage the original mount.
Note: if the mount around the cut-out is torn, the clips have nothing to grip and this frame won't fix it.
---
DEUTSCH
Zweiteilige Version von Chissi92s Reparaturrahmen für die Innenleuchte im Dachhimmel des Golf 5. Das Original ist 339 mm lang und passt auf kaum ein Druckbett. Hier sind es zwei gleiche Hälften mit 30-mm-Falz und Zentrierstiften, die zweimal gedruckt und zusammengesteckt werden.
Material: ASA, kein PLA, weil es unter dem Dach im Sommer über 70 °C heiß wird.
Einbau: Der Rahmen wird zwischen Leuchte und Himmel geklemmt, nicht geklebt.
Thanks to Chissi92 for the original model!