10.1" Raspberry Pi Touchscreen Case – Flush Wall Mount with Snap-In Cleat (ROADOM 1024×600)

This frame was made for Fabrica, a free, open-source dashboard for 3D-printer farms that I built for my own shop. It runs on a Raspberry Pi with a 10″ 1024×600 touchscreen (exactly what this frame holds) or any computer with Docker. It puts every printer on one wall screen:

• 🖨 Bambu Lab, Prusa, OctoPrint and Klipper side by side

• 📷 Live cameras and real finish times (“Done ~5:15 PM”)

• ▶ Start prints from the SD card with an AMS spool picker, plus a “bed is clear” check

• 🍝 Spaghetti detection (built on Obico’s open-source model)

• 💰 History and true cost per part · 📚 one file library for every printer

• 📱 Works as a phone app too · 🤖 AI agents (like Claude) can check and plan prints through MCP

• 🔒 100% local: no cloud, no subscription, MIT licensed

👉 Get it: https://fabricafarm.com (goes to the GitHub page with install steps)

ROADOM 10.1" Touchscreen Monitor, 1024x600 IPS Raspberry Pi Screen, HDMI

https://www.amazon.com/dp/B09XDK2FRR?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_10&th=1

A two-piece case (bezel + rear case) for the ROADOM 10.1″ 1024×600 touchscreen with a Raspberry Pi on the back, plus a wall rail so the whole thing hangs flush against the wall.

🛒 Screen it was built for: LINK_TO_SCREEN

✨ Features

• 🧱 Flush wall mount: a hidden 45° cleat with a snap that clicks when it’s seated

• 🔑 Keyed so the bezel only fits one way

• 🎯 Slotted screw holes for a little play

• 🖨 Prints in PETG, no supports needed

🔩 What you need

• 4 × M3 heat-set inserts (~4.25 mm tip)

• 4 × M3 × 18 socket head screws (no longer than 20 mm)

• 2 × #8 wood screws or drywall anchors for the wall rail