1 / 1
Top Rubber Bumper for Bogen or Manfrotto Autopole 2 — image 1

Top Rubber Bumper for Bogen or Manfrotto Autopole 2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Good replacement for a worn or missing top bumper for the Bogen/Manfrotto Autopole 2 Model #432. May work with others.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
16
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

One of my Manfrotto Autopole 2 lighting supports had its top rubber bumper go missing.  A roll of 'Foxtruder' 95A TPU was cheaper than a replacement part, so I figured that I'd give TPU a try for the first time.

Third time was a charm on a MK3S with 0.4mm carbide nozzle. 

I modified the SainSmart TPU profile in PrusaSlicer and used 6 perimeters and 5 horizontal shells, 15% grid/rectilinear infill, 0.2mm layer height, top/bottom contact Z distance of 0.3mm with a 2.5mm pattern spacing and 2 top interface layers, 75% XY separation, all speeds 20mm per second except support material interface which was 80%, 50mm/second travel speed, 1mm retraction length, 220C temperature and 50C build plate.

The replacement part has very similar stiffness to the original, it's just glossy instead of dull.  The area with supports has a rougher texture, but the supports pulled free from the part and remained stuck to the build plate when I pulled the bumper free.  No trimming or post-processing was needed.  The areas touched by supports are not seen while you are using the Autopole, so them being rougher does not bother me.  You could do a PLA support if they bother you.

Tags