Wall Holder for Hairbrush and Combs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A wall holder for a hairbrush, combs and hair ties.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 17
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
A wall holder for a hairbrush, combs and hair ties. The brush hangs by its neck in a 22 mm fork while the handle drops into a cup below, which has drain holes in the bottom so water runs out. Three 13 mm slots take combs, small brushes and hair clips. It fits flat and round brush necks from 12 to 20 mm and handles up to about 13 cm long. One part, 140 x 51 x 156 mm, mounted with 2 screws. Print it standing in PETG at 0.2 mm without supports. You need to buy 2 countersunk screws up to 4 mm and plugs.
Parts
Uchwyt na szczotke i grzebien bezbajzlu.stl x 1
Print settings
Bambu Lab A1, 0.4 nozzle, PETG, 0.20 mm layer
No supports needed
Full set: 5 h 50 min, 151 g