1 / 4
Mandalorian Helmet Trailer Hitch Cover - 2" — image 1
1 / 4

Mandalorian Helmet Trailer Hitch Cover - 2"

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€15.26 – €18.65 net (excluding VAT)

For file: mando helmet V3_Prusaslicer_0.15mm_PLA_MK3S_17h35m.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €16.95 excluding VAT (range midpoint).

Weight reported by the author
199 g
Print time reported by the author
17.58 hr
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

Mandalorian Helmet Trailer Hitch Cover for 2" receiver hitch

Rating
5 / 5
Likes
96
Downloads
442
Makes
1
Views
2,002
Reviews
1

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution

Remixed the Mandalorian trailer ball cover to fit into a 2" receiver hitch since I don't like leaving my hitch in all the time.

Printed with gray PLA, and colored the middle in with a few coats of black sharpie, turned out pretty nice.

Printed it with the helmet facing up (flipped 180 degrees from 3D image shown) so could vary the layer height and save time. I used 0.2mm layer height up until the bottom surface of the helmet and then switched to 0.15mm layer height to make it look a bit nicer. I printed without ironing.

Unfortunately, it requires a good bit of support material. No support material required inside the receiver hitch portion.

Just printed it, will see how it holds up and I'll update if I have any problems with it.

***November 2023 Update***: model broke where the reciever meets the back of the Mandalorian helmet. Remove from vehicle before going through automatic carwashes (this is what broke mine), or a similar failure is likely to happen.

 

***August 2024*** Uploaded additional make files (originally designed in NX, see .zip), gcode I used, and prusaslicer file, and relinked the model I remixed

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Supports:

Yes

Resolution: 

0.15

Infill:

30

Filament:

Prusament PLA

Gray

 

 

Category: Automotive

Tags