Worx WX051 Pegasus Work Table Sliding Anchor Set
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed a way to secure my table saw and other tools onto the Worx Pegasus table. The tracks provided a good basis.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 82
- Makes
- 1
- Views
- 839
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
This is a simple set that allows you to fasten anything to the Worx table using the integrated sliding track.
The plate goes into the track, and a 1/4"-20 countersunk screw can be used as the anchor. 2" screws should be good enough for almost anything.
You just need a 1/4"-20 nut to go with it, and the provided knob will fit perfectly for quick fastening. If you need some washers, you can print them too.
Depending on the size of the screw head, you may be able to use a button-head screw if it will fit in the slot below. I haven't tried.
I used Tough PLA, 3 perimeters and 50% Gyroid infill. Any infill good for horizontal support will do. How long will these last and how much can I wrench things down? Time will tell! As long as they're not stored clamped under pressure even PLA should be fine. PETG may be a bit soft?
Printed on the textured PEI sheet for a bit of grip. Maybe it makes a difference?