The very First Print
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This model shows in half an hour the real quality of every square mm of your print bed.
- Rating
- 5 / 5
- Likes
- 445
- Downloads
- 3,175
- Makes
- 15
- Views
- 26,993
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- GNU General Public License v3.0
TL;DR
Single layer whole print bed, see how good or bad it comes out, no change to hide anything.
Collection
update 2026.1001 - Sovol ZERO
added Sovol ZERO -> the tiny blue square
ES_Sovol_Zero_152x152x0.2.3mf
ES_Sovol_Zero_152x152x0.4.3mf
(one of the best auto calibrated first layers, maybe the best)
update 2026.0702
added Elegoo Centauri Carbon2 (fullsize 256x256x0.2)
added Elegoo Centauri Carbon2 (fullsize 256x256x0.4)
CC2_full_print_bed
Note, the 3mf profiles above establish a modified printer called "CC2_full_print_bed". This config removes the reserved area [[246,0], [256,0], [256,20], [246,20]] so you can use the full print bed.
The printer primes at the beginning of the print into this area but the infill starts at the back so you can remove the prime line before the printer reaches this zone.
You can use this setting without issues and limits you have just to be aware that this region gets the prime line at the start of a print. Don't place objects there or remove the line at the beginning of the print.
update 2026.0221
added Prusa Core One 250x220
added Bambulab H2S 340x320
added Sovol SV08MAX 500x500
update 2023.0613
added 3mf config file for Prusa Mini
update 2023.0226
added 3mf for bambustudio
cleaned up the description
Let's get started
Full Print Bed
This nice model is useful to check and improve the leveling of your whole print bed. It is not a first layer calibration. You should run the first layer calibration first and use this model to check your whole plate.
If you find in your print areas where the lines are not connected or the print is not well bond to the bed you have a lot of options.
level your bed
clean the print bed with IPA or what needed
use a thicker first layer
use a higher extrusion wide for the first layer
print the first layer slower
print the first layer hotter
Other issues
Burned pieces, scratched pieces any kind of over extrusion.
Go one step forward and run the first layer calibration first.
Attribution
Can I sell copies of this?
Yes! Yahbluez shared this project under the GNU GPL v3.0 license. This license allows selling copies, but you must provide proper attribution and use the GPL 3.0 license, as detailed in the GPL v3.0 license itself. You have not the right to use any other licence than GNU GPL 3.0.
Donation
If you like to donate you can buy me a coffee
Filament used
works with any filament