1 / 6
Honeycomb HSW Hidden Magnet Mount for three 6mm x whatever magnets — image 1
1 / 6

Honeycomb HSW Hidden Magnet Mount for three 6mm x whatever magnets

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Magnetic insert with hidden three 6mm magnets with arbitrary thickness.

Rating
5 / 5
Likes
44
Downloads
204
Makes
2
Views
951
Reviews
2

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Magnetic insert with hidden three 6mm magnets with arbitrary thickness. Magnets should not need to be glued, they should hold by the friction (mine do). Even with “standard” 6x2 neodymium magnets (e.g., usable with Gridfinity) it can hold quite a lot (see photos). Combine several of these inserts to hold almost anything - 2 of these can hold my steel L-square angle without any problem.

Note: Pay attention to all the magnets be inserted with the same polarity. Also, wait for the print to cool down - standard neodymium magnets start losing their magnetism at ~80°C (~176°F).

Remixed from Shoe's Honeycomb HSW Magnet Mount 10mm x whatever.

Print instructions

Print it with it's front down. No supports needed. In PrusaSlicer, you may want to:

  • Go to Print Settings → Layers and perimeters → group Advanced:
    • Switch to Classic perimeter generator from Arachne
      • Advanced mode needs to be enabled to display this setting
    • Turn on External parameters first
      • Expert mode needs to be enabled to display this setting
  • Set Variable layer height to thinner layers for the top part of the pads
    • This should make them easier to insert
    • If you have layer height of 0.15-0.20mm, you can ignore this settings. If you are using a bigger nozzle (0.6mm and bigger), you will probably want to experiment with this.

You can switch between the modes in the top right corner of the Settings window. This will lead to properly printed “pads” that are supposed to click into the wall and also a very tight fit - I had to use a hammer to put my inserts in place. Consider scale the model to 99% to avoid such a tight fit and experiment with results.

Note: The holder on the first 2 photos was printed with old settings, so you can see how deformed the pads turned out to be. I'm also attaching gcode for printing this with 0.6mm nozzle and recommended settings (external parameters first, classic perimeter generator, and variable layer height for the pads).

 

Tags