Spool Holder Printable on 10cm Cubed Tiny Printer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Specifically designed for the Entina Tina2S but will print on any 100mm x 105mm x 100mm 3D Printer.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 49
- Makes
- 0
- Views
- 212
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Update-30/12/23: I rotated the base piece slightly so it fits properly on a 100x105 Bed. And I added a little lip to the spindle so you don't glue the bearing shield in place
This handy spool holder is great for any little printer. If you bought a small printer, and later realized the 1KG Spools wont fit on the tiny holder. Than this is the print you need!
Prints in 7 pieces. Glue a pair of 608ZZ bearings onto the spindle and the rest snaps together, the uprights should be a tight fit. You can scale up the base pieces by a couple percent if you need to.
Print 2 of each part except the Spindle, support is recommended on the Base pieces, and required on the Spindle.
I've included the stand in 608ZZ bearing, model by @riffraffs_375299 so you can print those out if you don't have the real bearings. I've found that the cardboard spools tend to knock the spindle off when they near empty, if you don't have the bearings.