3D Printing filament rack for 45° roof slope
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Uses the 3D printed parts combined with 30mm round wood to make a filament rack for 45° sloped walls (eg. roof spaces)
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 29
- Makes
- 0
- Views
- 363
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
There are plenty of nice designs for filament storage solutions for classic straight walls, however our hobby and 3D printing room is in the roof space and we had dead space on a 45° sloped wall that we wanted to make use of. I couldn't find any suitable designs so I came up with this in Tinkercad.
The build requires you to print one "left" part, one “right” and as many middle pieces are you want depending on the length of your filament rack. You could just use middle pieces but the left and right models provide extra strength and are optimized to prevent the rolls falling off the end. If you had a wall or furniture enclosing from left and right you could build with just “middle” pieces. The advantage of the middle pieces is the ability to slide roll left and right - the left and right pieces prevent this.
Requires:
- 2 x 30mm diameter round wood (dowel)
- 25/30mm screws for fixing round wood (may require pre-drilling for hard wood). Width can be varied to your requirements.
- approx 50mm screws for fixing the brackets to the wall
We used 1m lengths of 30mm diameter round wood. The heavy duty version of the middle sections were designed for use where connecting wood is necessary. We used a middle section every 20cm.
So for example if you want to make a 1m rack with supports every 20cm you would need:
- Two 30mm round wood 1m length
- 1 x left part
- 1 x right part
- 3 x middle parts
I printed in PETG with 5-6 walls (15% infill) for optimal strength. Designed to fit onto a normal format printer bed MK3/MK4/Bambu X1C/Ender 3 and derivatives. The parts can be printed flat without supports.
Here is the link for our slide-able filament type labels for the 30mm round wood you can see in the photos:
https://www.printables.com/model/651225-filament-type-labels-for-30mm-round-woodtube