BAMBU LAB - BLLED CONTROLLER AND POWER TAP CASE

BAMBU LAB X1C / P1S BLLED CONTROLLER AND POWER TAP CASE
!!! The .3mf file is a ready to print Bambu Studio File !!!


If you are installing an additional LED stripe into your X1C / P1S Printer, you problaby will also use the BLLED Controller from DutchDeveloper.

This controller is powered by 24V so you have the option of using a seperate power adapter or using the 24V of the AMS.

If you will be powered over the AMS there is also an additional controller board (splitter) from 3DMachinist you can buy on Etsy

------------------------------------------------------------------------


I completely made this design simple but super useful and protective for all of the connectors.
The Cable outlet for the LEDs is located on the TOP Side

++ Power Tap
+ Click in Design - The inner walls will hold the board installed in place - so basicly no additional screws needed
+ Fan Grills for great airflow and air cirkulation
+ addittional support inside of the case to prevent the connectors from bending because of plugging cables in and out, the supports are provided for all directions
+ 3x guiding pins for the power tap bord and 1x hole for additional fixing the bord with a screw (M2x6mm, optional)
+ small cutouts for the connectors

++ BLLED Controller
+ Click in Design - The inner walls will hold the board installed in place - so basicly no additional screws needed
+ Fan Grills for good airflow and air cirkulation
+ Added BLLED Logo and connector info
+ Precise fit usb-c cut-out
+ Precise fit single cable cut-outs 
+ Precise fit screw access

+++ PROTECTIVE BACK COVER
+ Slide-in / Click-in Design - Simply slide in the Cover, it will be securly locked when completely slided in
+ a hole cutout for mounting screw

Adiditionally needed to mount the Case to the Printer
1x M3x22mm screw

1x M2.5x22mm

Please print with materials like ABS or ASA
I desided to use ABS gray for the Case and ABS Black for the fonts and the logo because of the color of the X1C

I would love to here about your feedback. If you have any additional ideas,,, let me know.


------------------------------------
UPDATE 28.12.2023
I made an additional one case with vertical orientation without the need of screws.
For installing on the back of the printer i can recommend velcro tape
- USB-C accessible from the top
- LED cable accessible from the side

I also increased the outer wall thickness of the case from 1,45mm to 2mm 
because of prevent breaking walls when slide in / out the cover


------------------------------------
UPDATE 01.02.2024

There are two different PCBs are used for the powertab. 
They both are V1.3 but colored Purple or Blue. Both have minimal differences in the dimensions wich i specificly optimised in V.2 for the Blue PCB

- optimised for the Blue Powertab PCB (V2 )
- optimised the Lid and Case for much a smother slide-in closing (V2)
- optimised the BLLED Case because of compatibility issues with some cables/connectors (V2)
- added 3mf for both case versions pre-conf for PLA (V2)
- renamed the .stl files → 
  V1 is purple pcb and V2 is blue pcb → 
  V1.1 and V2.1 is made for used with screws → V1.2 and V2.2 without Screws