Pegboard - Hammer (10oz) Peg
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.72 – €0.88 net (excluding VAT)
For file: Anvil Hammer Peg_0.4n_0.2mm_PLA_MINI_56m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.80 excluding VAT (range midpoint).
- Weight reported by the author
- 7 g
- Print time reported by the author
- 56.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Reliable, quick, and tight fitting peg to mount a hammer to a 1/4" diameter holes, 1" spacing, pegboard.
- Rating
- 4.333 / 5
- Likes
- 42
- Downloads
- 273
- Makes
- 4
- Views
- 601
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
A simple pegboard mount for a 10oz Hammer. I want to keep my pegs fairly lightweight, but at the same time I want to make sure that heavier or more dangerous tools to leave hanging always want to move toward the wall, and not away from it. This becomes particularly important if you're quickly picking up and putting back tools - anything that helps a tool ‘fall back’ toward the wall is a good design choice.
Extending on my Standard Peg design, and using measurements for my 10oz Hammer (Anvil), which is asymmetric, I set up two hooks at different heights to hold the hammer such that the shaft was vertical. This also means that there is a ‘correct’ direction to place the hammer on the pegboard, with the blunt end facing to the left.
I hope you find this useful - and if there are variations needed for different types of hammers, let me know :)