1 / 5
Holder for under-cabinet light in the original prusa enclosure | Halter für Unterbauleuchte im originalen Prusa-Gehäuse — image 1
1 / 5

Holder for under-cabinet light in the original prusa enclosure | Halter für Unterbauleuchte im originalen Prusa-Gehäuse

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Holder for under-cabinet light in the printer housing (original prusa enclosure)

Rating
0 / 5
Likes
3
Downloads
13
Makes
1
Views
197
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution
English (Translated with DeepL.com):

Simple bracket for lighting for the original Prusa housing.

Here is the under-cabinet light: https://www.amazon.de/gp/product/B07H8D212R/ 

Additional material required: per lamp: 2 x M3x10 or M3x8 or M3x6 screws

You can screw all three lamps into the corners. Then you need 6 of the brackets.

I only screwed one lamp into the corner on the right and left. No nut is needed. Simply screw the screws into the plastic part. I screwed the third lamp to the ceiling of the housing using M3 screws and the brackets supplied. With this setup, only four of the brackets are needed.

I attached the switch and the dimmer to the outside of the housing with double-sided adhesive tape (mirror tape). The cables are rolled up and attached to the eyelets on the housing using cable ties. Works perfectly and is quick and easy to build.

See pictures.

You have to choose the material depending on the temperatures you generate in the housing. I have up to 45°C in the housing and PLA is sufficient.


 

Deutsch:

Einfache Halterung für eine Beleuchtung für das original Gehäuse von Prusa.

Hier die Unterbauleuchte: https://www.amazon.de/gp/product/B07H8D212R/

Benötigtes Zusatzmaterial: je Lampe: 2 x Schraube M3x10 oder M3x8 oder M3x6

Man kann alle drei Lampen in die Ecken schrauben. Dann werden 6 von den Haltern benötigt.

Ich habe nur rechts und links eine Lampe in die Ecke geschraubt. Es wird keine Mutter benötigt. Die Schrauben einfach in das Kunststoffteil drehen. Die dritte Lampe habe ich mit M3-Schrauben und den mitgelieferten Haltern an die Decke des Gehäuses geschraubt. Mit diesem Aufbau werden nur vier von den Haltern benötigt.

Den Schalter und den Dimmer habe ich mit doppelseitigem Klebeband (Spiegelband) außen am Gehäuse befestigt. Die Kabel werden mit Kabelbindern an den Ösen des Gehäuses zusammengerollt und befestigt. Funktioniert perfekt und ist einfach und schnell gebaut.

Siehe Bilder.

Je nachdem, welche Temperaturen ihr im Gehäuse erzeugt, müsst ihr das Material auswählen. Ich habe bis 45°C im Gehäuse und da ist PLA ausreichend.

 

Tags