1 / 3
Dig-Uno and Mean well LRS-50 enclosure — image 1
1 / 3

Dig-Uno and Mean well LRS-50 enclosure

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple enclosure for Dig-Uno WLED controller and Mean Well LRS-50 series PSU

Rating
0 / 5
Likes
4
Downloads
37
Makes
0
Views
282
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

I needed an enclosure for a Dig-Uno and a Mean well LRS-50-5, and wasn't happy with what else I saw out there. So I made this one.

 

Prints at a 45° angle, for extra strength and less notable layer lines. Support for this printing is baked into the model. Removing the support can be done by hand, although I recommend a pass with a random-orbit sander, to remove leftover support attachments.

 

Additional support is beneficial, but not required, around the two openings for cables.

 

You will need a few additional components:

 

  • 4 M2x2x3.2 heat set inserts, to mount the Dig-Uno (You could probably make do with 2 diagonally
  • 4 M2.5x2.5x3.5 heat set inserts, to attach the lid to the box
  • 4 M2.5x6 screws, for the lid
  • 2 M3x6 screws, to attach the LRS-50 to the bottom of the box

Assembly is fairly self, explanatory, and there are hints embossed into the inside of the bin. Just make sure you orient the Dig-Uno the right way.

 

This works with all Mean Well LRS-50 PSUs, not just the LRS-50-5.

Tags