Counting matching models…
(20th Oct 2025) Updated with slight design changes available here:- https://www.printables.com/model/1451045-blokeesamiibofigure-stackable-display-shelf-v2 This is a stackable shelf I made for putting my Amiibos in a vertical tower to…
I really wanted ear hooks for my Old Fashioned... but I couldn't find anything nice so I decide to give it a shot and design one myself. Printing Notes Make sure your printer is very well calibrated because We're printing small fine…
Refresh of my stackable shelf design for figures cause now I have a pile of Blokees instead of Amiibos! Base plate is now a bit thicker to better handle the weight, rods are now looser with a 0.3 tolerance between the pegs and the hole.…
My Xreal One Pros were at a bad angle, I noticed it was because the “ear grooves” in the arms were too deep, so I made some stands that can stand it up higher. Then I noticed that the glasses slowly slid down my nose like all glasses tend…
This is a container whose primary purpose is to protect the triggers and bumpers of the GPD Win Mini when it's put inside another bag. The container has nubs in the ends to offset the bumpers and triggers so that no pressure is applied to…
IMPORTANT NOTE :- THIS WAS DESIGNED FOR MY OWN USE AND I POSTED IT HERE FOR EDUCATIONAL PURPOSES. I'LL NOT BE RESPONSIBLE FOR ANY DAMAGES TO YOUR SWITCH OR ANYTHING THAT HAPPENS DUE TO THE USE OF THE CASE. This is a case I designed for…
So.. I had this FOUR year old roll of blue ABS that's been sitting around in a non air tight container.. and also.. a messy drawer full of portable USB hard disks. So I designed this quick and dirty stackable slot holder to organize them…
Decided to try and design a pair of grips for the GPD Win Mini, uploading it here so mayb it can serve as an inspiration for other designs. No, you cannot close the device when the grips are installed. !!! WARNING !!! This is uploaded for…
A leverless FightStick… Board of my own design which is running off the GP2040CE firmware on a Raspberry Pi Pico board. The holders are meant to be used with a Kailh Low Profile V1 switches, which I don't think they're even available…
Wanted some longer nose pads for my XReal One Pro so I decided to give it a shot. Printing Instructions Printer must be able to deliver proper print accuracy due to the small gaps required. Suprisingly I used PETG for my prints and it…
These are all currently available results.
