Ultimate Creality K1max Mainboard fan upgrade

IMPORTANT: Some people may encounter fan errors after upgrading the fan, so I recommend keeping the stock fan in case you need to revert back to it. Personally, I control my printer via Fluidd and have only encountered the error once during the months I've been using this mod.(I think it has something to do with Creality interface)
UPDATE ON THE ERROR: When it happens, one fan still works. Error disappears when print starts or if not lower SOC temperature manually and the fan will kick in. 

I printed "Motherboard fan mount" made by Henlor and installed stock 6015 fan on it. 
Also thanks to Davethegearhead for printer.cfg instructions/

I found 8015 24V 2500rpm 0.15A fan locally that is decent quality and is 3pin, designed a cage for it and replaced the small stock fan(needed to resolder connector from old fan to new one).  Fan works the same as previous fan, still turns off when the printer sits idle. 

With this setup MCU temps stays under 45C while printing and stays at 38C on idle with 10-20%  6015 fan running. 

Printed in PETG.
0.2 layer height.
3 walls.
25% cubic infill.

For assembly:

4 regular PC fan screws. (for the fan)
4 flat head self tapping screws M3-5mm. (to secure the cage to the plate)
I also added a brim of hot glue around the fan cage after everything was assembled for extra strenght.

Printer must be standing on stock "anti vibration" rubber feet or higher.

KEEP IN MIND THAT I HAD TO SWAP FAN CONNECTORS.
1. Cut off the 3 pin connector from the stock 6015 fan.
2. Solder it to your new 8015 fan.
3. Take a new 2pin (i think it's JST-PH2.54 , but not 100% sure, I just had some laying around).
4. Solder it to 6015 fan. (leave yellow wire hanging.)
5. Now connect 2pin to 2pin slot, 3 pin to 3pin on the mainboard.
6. The 8015 fan will work as stock 6015 worked before, no changes necessary unless you want to.
7. For the new 2pin connection you need to make changes in printer.cfg so the fan would start working. Open printer.cfg and comment out these lines:
   [temperature_sensor mcu_temp]
    sensor_type: temperature_mcu
    min_temp: 0
    max_temp: 100

Then add new lines that should look like this:
[temperature_fan MCU_fan]

pin: PA0

kick_start_time: 0.8

off_below: 0.1

max_power: 1.0

sensor_type: temperature_mcu

control: pid

min_temp: 0

max_temp: 100

pid_kp: 1.0

pid_ki: 0.5

pid_kd: 2.0

min_speed: 0.1

max_speed: 0.8

target_temp: 38

8. That's it :)