Liczymy pasujące modele…
5mm thick reinforced panel, but with the included parametric Fusion file it can be easily changed to any desired thickness. Offers 10 port keystone, width is 254mm. Easy print: 0.2mm layer height, 10-15% infill. Support my work Do you…
Yet another 10 inch blank cover — what's the difference? First, I needed it 5mm thick, which later became parametric in Fusion, and the file is also attached. The geometry of the cutout gives more wall around the screws, and the whole…
Standard 19" 1U blank panel, split into two halves along the width so it fits on consumer-size beds (designed and tested on a Bambu P2S — no bed over ~250mm needed). The halves join with a dovetail slide, sized with a deliberate tolerance…
MikroTik CRS305 Dual Rackmount — 1U, 19", LEDs Front, Fan-Ready Mounts two MikroTik CRS305-1G-4S+ switches side by side in 1U of a standard 19" rack. Most CRS305 rackmounts turn the switch around so the SFP+ cages face front — convenient…
OpenGrid Rack Ears — 10" front and shallow-rack side mount A remix that lets you snap OpenGrid plates directly onto a rack, either across the front of a 10" rack or down the side of a shallow rack (350mm internal depth). Turns dead rack…
Rack tray for 5x ESP32-S3-DevKitC-1 boards, organized for ESP32 clustering. Personally used to run AI agents, but also fits nerdminer clusters, experimentation rigs, or general dev board wrangling. Compartments are designed for easy…
A minimal Raspberry Pi 3B case with fan support, built for OpenGrid using the OpenConnect connector system. Fusion archive and step file included. Support my work Do you like my work? A like or a comment means a lot and keeps me making…
Elecrow 5-inch touchscreen display (SKU: DIS05490T) mount for OpenGrid with OpenConnect connectors. Fusion archive and step file included. Support my work Do you like my work? A like or a comment means a lot and keeps me making more. Post…
A minimal hook designed specifically for the IKEA TIMMERFLOTTE sensor based on David 's official bare snap for openGrid. Snaps onto standard OpenGrid panels. The sensor hook is an intentionally snug fit, not loose — this keeps the…
This design takes Framework's repairability philosophy and applies it to the enclosure itself: a modular, customisable case where every part can be replaced or remixed. The goal was an enclosure that is easy to remix, uses multiple…
To show how modular Airframe 12 is, I remixed its back panels so the case attaches to openGrid tiles. You can hang the enclosure on a wall or mount it on an openGrid tool tower. The panels replace the originals and use the same 6 × M3x6…
A minimal, wall-mounted stand for the Home Assistant ZBT-2, built for OpenGrid using the OpenConnect connector system. Fusion archive and step file included. Support my work Do you like my work? A like or a comment means a lot and keeps…
Rack tray for 10x ESP32-S3-DevKitC-1 boards, organised for ESP32 clustering. Personally used to run AI agents, but also fits nerdminer clusters, experimentation rigs, or general dev board wrangling. Compartments are designed for easy…
To wszystkie aktualnie dostępne wyniki.
