Liczymy pasujące modele…
Here is another tripod mount for the MFD Crossbow Mini AAT. This one you're able to use either the SIYI HM30 video link, HDZero VRX, or the Walksnail VRX. I made the HDZero and Walksnail VRXs slide in type mounts. The HM30 uses a ¼ 20…
Replacement nose for the Heewing T2 Cruza. I wanted more air for my VTX and this is what I came up with. It's a little heavier than the foam nose of course. Depending on how you plan to set it up the minimum hardware you'll need are 4 -…
When printing the nose i laid it on it's back. Uses a lot of support but it makes for a smoother looking print. I imagine someone can cutoff the cape type thing i have on the nose to make the transition to the fuse a little smoother. Up…
Here is another nose for the T2. This one is for the HEQ G-Port gimbal. This is the Walksnail version. I did include STEP and Fusion360 files if someone wants to change it for the DJI version. I went back and forth on an underslung mount…
Depending on what fan size you plan on using you'll either need a 4010 fan or a 3010 fan. Pay attention to the current draw of the fan and keep it as close as you can to the original. I don't know what the VRX is fan output is rated for…
Gimbal protector for the Jumper T20s. Will need to be printed with supports.
I needed a better venting 2.2 wheel for some silicone foam inserts i made. I came up with these. I haven't had any issues with the outer “Tabs” of the bead rings yet. But I haven't ran them too much yet. Ive used PLA and also ASA for…
This is a mold to make your own silicone 2.2 tire inserts. I went through a few iterations to find what I think works pretty good. The rings I'm still unsure about. When I designed them I figured it might help with getting the mold apart…
I printed mine with it standing on end as you can see in the pics. It printed good for me in this orientation and looks clean. The template is so you can mark and punch holes in the bottom of the fuselage so you can take the VTX in and…
Materials you'll need 4 - M2.5X3.5X3 heat inserts. 2 for each tray. 4 - M2.5X6 countersunk screws. I used ASA filamet for mine. I think any higher temp filament should be fine. You'll have to cut out some foam in the wings to glue these…
You'll need 8 - m3X4.5X3 heat set inserts. I used some i had out of this assortment . But these will work as well m3X5X3 Print with a high temp material. I used ASA for mine. Its probably overkill but I printed mine with 100% infill. The…
I fly long range fpv airplanes and was always worried about crashing and not being able to find the plane. So I came up with this setup to keep the RX running even if the main battery is ejected. Depending on how you set it up you can…
I had some ProModeler DS100DLHV micro servos laying around and wanted to use them in my Mini Crosswind. The servo trays are slightly bigger than the original so you will need to trim some foam to use them. They're 1mm wider and 5mm longer…
the plastic pieces in my kit had a slight bow to them and I wanted to make sure they were glued in properly. This is what I came up with. You'll need 8 m3X5X5 heat set inserts as well as 8 m3X10 screws. You should be able to print…
To wszystkie aktualnie dostępne wyniki.
