Liczymy pasujące modele…
Nikon Z mount lens holder for the gridfinity system. There are 2x2 and 3x3 versions of this holder depending on the diameter of your lens. The 2x2 is great for leaving a space between lenses and printing out a 1x2 cf express, sd card, or…
Heatset threaded insert I'm using can be found here: https://www.amazon.com/gp/product/B08PVQX853/ Reinforced the area the insert goes into. Everything else is the same as their original design other than the insert hole and the inset…
My FTM-500DR control unit took a tumble and I lost one of the knobs after it popped off. Yaesu didn't respond to support requests so I decided I didn't want to wait and printed my own replacement knob. I've made two versions of it due to…
Made this to aid in the replacement or changing of orientation of the mag catch in a Canik Rival-S. The channel for the mag catch spring in the Rival-S is rounded which makes it extremely difficult to hold in place while reinserting the…
Nikon Z9 holder for the gridfinity system. It fits in a 4x2 footprint in a standard gridfinity base. There is recess that will fit a PD Capture clip plate with tethers attached. It will fit other arca plates as well but I haven't tested…
I created an extended cap for the RigExpert Stick analyzers that works with the SO239 adapter attached and has a loop that allows you to keep it tethered to the bottom loop on the analyzer. There is a little bit of a lip that doesn't…
Designed a mount for the Yaesu FTM-500DR/510DR for a Model 3/Y Tesla. My Tesla is older with the flip up charging tray so I needed something the tray would clear hence the offset. There's a 18mm hole that will allow an M5 thumbscrew to…
A variation of my original Yaesu FTM-500/510 Tesla model 3/Y mount that sits flush on the bottom left of the center console screen produced in collaboration with Sam M. He had a folding hinge bracket we fit to the model to allow you to…
Note: This is only a replacement cover but the instructions, spacers, and supports should all be used from the original model here . Huge thanks to IPIND 3D for including the step file and making the remix quick. The switch used is no…
I installed the gas struts mod for the Prusa XL enclosure and the existing camera mount wouldn't work. It also wouldn't mount in the top hole. It was modeled from scratch but inspired by Robert's design. Printed with a .4mm nozzle and…
Made an EnXLosure mount for a Unifi G3 Instant cam. There's a cable channel to tuck the cable behind the mount. Remove stock G3 Instant swivel mount, retain stock mount bolt and reuse. Options for attaching to enclosure: Insert an M3…
The original model's mounting holes for the screws included in the AIRTAK enclosure (https://a.co/d/awk5IxF) were not wide enough nor were the recesses deep enough. Use this AIRTAK base plate with the rest of the original parts. All other…
Needed a riser for the GeeekPi Raspberry Pi 4 case to accommodate a Loverpi isolated PoE hat and would allow the 40mm x 10mm case fan to clear. I added some vents on the side to accommodate the case being on a flat surface with little air…
To wszystkie aktualnie dostępne wyniki.
