PTFE Lined Filament Guide for 3D Printers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are remixed versions of the filament guides I'm using on several machines with larger throughways for PTFE
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 23
- Makes
- 0
- Views
- 465
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v3.0
While I'm not at all a fan of reverse Bowden setups, I've been working with hygroscopic materials, direct drive machines, and printing directly from my filament dryers as of late.
I'm revisiting an old design I use for “open air” direct drive printing and modified it to anchor one end of PTFE tubing at the top of these machines, while having the other end of the PTFE tube directly inserted in a filament dryer.
My intent is to use the short guides on a pair of CR-10 clones, a CTC A10s and Sunlu S9 Plus, and have them directly paired and connected to a dual spool dryer I just picked up, the Fixdry NT1, as those two machines lack the vertical space in their assigned locations to mount spools from above.
While none of my old guides have worn from use to the point of having to reprint them, I may replace some of my existing guides with these and a 12mm long piece of PTFE tubing. The idea for that use is that if the tiny piece of PTFE tubing wears, I can simply push it out and replace it with new and NOT have to reprint these guides.
Whether you use these guides with a reverse Bowden setup or routing filament in open air situations, the PTFE liner should help to reduce friction between filament and the guide itself.
Pay no attention to the sloppy mess in the photo's. I installed the short version atop my CTC A10s and tested it with TPU, then needed the dryer in that machines temporary location for a 20hour print I'm doing for my son, so the images only illustrate the installation, not the function, but hopefully it will make sense.
I'll try to remember to post updated photo's once I convert the other CR-10 clone to direct drive and have my machines properly situated.
Both of these guides print easily as oriented in the STL's with no need of supports.