1 / 5
Duct wall clamp (150 mm / 6 inch)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Screw in wall/surface clamp for holding up 150 mm ducting in position. Good for long runs
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 96
- Makes
- 0
- Views
- 369
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Ducting clamp
Designed to hold 150 mm OD air ducting onto a wall, surface or underside of a table with screws. Prints in two parts (TOP and BASE).
- Model has 160 mm ID clamp for a good loose tolerance (no need for a tight fit with this)
- Designed to print on 220x220x240 beds (Ender3)
- You can print 3 of these at once if arranged correctly (see Cura slicer picture for layout example)
- Screw holes are designed around timber screws:
- Zenith 8G x 25mm Stainless Steel Long Thread Countersunk Head Timber Screws
- Can be bought from Bunnings Hardware in a 10 pack (also bigger packs if needed): https://www.bunnings.com.au/zenith-8g-x-25mm-stainless-steel-long-thread-countersunk-head-timber-screws-10-pack_p2420100?srsltid=AfmBOoowFc3sFK1jfNFswivlflSqVdRre0bqg-ic9NpAv4YmIisd-Qoa
- 3x screws on the bottom to screw into surface (two is good for most applications).
- 2x screws join the TOP and BOTTOM parts, the hole is a little undersized so that the screws can cut into the plastic and have a good hold.
If you like this design, you can say thanks by buying me a coffee via Paypal:
https://www.paypal.com/paypalme/moneysump