Air Rifle Silencer / Moderator / Suppressor - Barrel mount / No thread. Always aligned!!. F3D included.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Silencer design for Gamo Expo (Sniper) Air Rifle. Barrel mount, F3D included for fitting to other non threaded barrels.
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 58
- Makes
- 0
- Views
- 915
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Barrel mount silencer / moderator / suppressor, for non threaded barrels. (F3D inlcuded to fit all).
I tried a few other existing barrel mount stl's but one slight knock and they were no longer true so the pellets smashed the end of the silcencer next shot. As such this has been designed to remain true, with all expected handling / knocks.
Silencer designed for Gamo Expo (sniper) air rifle 0.177. F3D included to ensure other barrel mounts supported.
F3D included for quick modding to fit other air guns with non threaded barrels.
You will need M6 heat inserts and screws and some open cell scotch brite type pads. (Note that a close friend, with the same but newer rifle, has not used the heat inserts and screws, and has had zero issues - the barrel fit tolerance and length is sufficient to keep all aligned). If you wish to ensure no rotation: "end cap top is flat" (so as not to inerfere with sighting); use the heat inserts / screws).
The heat insert holes are best pressed in when the silencer is on the barrel; the hole size is designed to leave a small PETG layer between barrel and screw to prevent barrel marking.
Printed in PETG with following settings: 0.15mm structural, 4 perimeters, 40% infill, supports snug.
Be sure to clear the 4 off 'gamo silencer insert' parts air holes of support material, along with all of the inner bore diameters, the back end of suitably sized drill bits work perfectly.
Roll one of the 'gamo silencer insert's across the scotch bright pad length ways, to see where to cut; one length wrapped around the 'gamo silencer insert' fills the void perfectly.
Push the 'gamo silencer insert' parts home (4 needed); the 4 should marry up to the front face of the silencer perfectly.
I attached my 'gamo silencer end cap' with a little hot glue so its not to permanent, and packing can easily be replaced if needed.
Double check the inner bore is fully clear and fully aligned before shooting, (look down the barrel towards light source when installed). Alignment should be spot on based upon maths from the files, you're really checking for left over support material. If its not clear fix it.
We have used a full tin and a half of Exact heavy diablo pellets, and 3/4 of a tin of BSA storm pellets since installation. With supervised, but clumsy minors using it at times, no issues, alignment remains perfect > 1800 pellets.
If you want to mod it to fit your barrel, mod the 'gamo silencer test print' file F3D in FUSION 360 until its a snug fit, then apply same mods to 'gamo silencer' F3D, then export as STL and print with settings as above.
