ReSpeaker XVF3800 (+ XIAO ESP32S3) Case with LED Light Ring
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slim black puck enclosure for the Seeed ReSpeaker XVF3800 4-mic array with a white light ring for the 12 RGB LEDs. No sp
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 29
- Makes
- 0
- Views
- 94
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Public Domain
A compact, low-profile case (Ø 109 × 15 mm) for the Seeed Studio ReSpeaker XVF3800 USB 4-Mic Array with XIAO ESP32S3. The body is printed in black and a separate white ring sits right above the 12 WS2812 LEDs, so the direction-of-arrival / status light glows through as a clean ring.
The model is built from Seeed’s official STEP file of the board and checked for collisions against it.
Features
Both USB-C ports (XMOS and XIAO) and the 3.5 mm jack are accessible. The openings are wide enough for cables with bulky plugs.
Both side buttons (Mute and Reset) work through small printed push buttons.
4 mic ports with short acoustic tubes that lead right to the microphone holes in the PCB
White light ring over the 12 RGB LEDs. Thin bridges between the LEDs hold the lid together and stay hidden under the ring.
Small white light pipe for the red Mute LED
No speaker chamber. If you want one, there are other great designs for that.
No supports needed
Parts
base_black.stl: black
lid_black.stl: black
ring_white.stl: white / natural
led_pin_white.stl: white / natural
plunger_left_long.stl + plunger_right_short.stl: black
The two buttons are different on purpose. The right switch sits on a PCB tab 1.35 mm further out, so its button is shorter. Left and right apply when viewed from the top (LED side up) with the XMOS USB-C and the jack facing you.
Hardware
3× M2 × 12 mm screws. DIN 912 socket head fits flush, or use a self-tapping screw for plastic with a head up to Ø 4.2 mm. Use exactly 12 mm: shorter won’t hold, longer can push through the top of the lid.
A drop of CA glue for the ring (optional if it’s a tight fit)
Optional: 3–4 small rubber feet
Assembly
Push the white ring into the lid from the top, notches down onto the bridges. Secure it with a drop of glue.
Insert the LED pin into the lid from below until its collar seats. The PCB keeps it in place.
Put both buttons into the wall holes from the inside, collar inwards: the long one on the left, the short one on the right.
Drop the board into the base. The connectors slide into the open-top cut-outs.
Put the lid on and fasten it from below with the 3 screws. Don’t overtighten. The screws cut their own thread in the plastic.
