Silent Spool Holder For Ikea Lack
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quite was the goal. New V2 Base makes it even quieter ...... Now I don't hear my spool as I print! Victory
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 32
- Makes
- 0
- Views
- 305
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Started this in an attempt to make my printing quieter. Turned into a bigger project than I anticipated. As not all spools are the same dimensions I made this to accommodate most.
.
Materials needed Base V1 with any holder.
(2) 608-2RS Bearings.
(2) 1" Cotter pins.
(1) 5.5" X 8mm Rod ( Or smaller diameter )
Base V2 Doesn't need Cotter pins, uses (4) Bearings, and needs supports.
.
As far as the differences in styles of Spool holders
V1/V2 Don't tighten centric in cardboard spools. May need to scale part 2 to 101%-103% depending on printer.
V3/V4 Have a better taper to accommodate more filament brand spools. V3/V4 I scaled even in sets, but if you find its tighter then you like scale Part 2 by +1% until you reach desired tightness. Part 2 uses very little filament.
.
Print Settings for Base V1. (Ender 3 Pro PLA+). Use what works best for your printer Orient bottom to bed. (Should be pre-oriented Not Sure) My settings for V1 cut time down to under 6 hours.
Use what works best on your printer, V2 Base Needs Supports
My fast settings are.
.3 Layer Height.
.2 Initial Layer Height.
3 Top/Bottom Layers.
2 Top Surface Layers.
15% Infill Cubic.
60 mm/s print speed.
35 mm/s Infill Speed.
35 mm/s outer wall speed.
45 mm/s inner wall speed
160 mm/s travel speed
For Spool Holders All Part 1s
.15 - .2 Layer Height
.15 - .2 Initial Layer Height depending on Layer Height.
25% - 99% Infill ( Use Concentric for 99% ) Otherwise use gyroid, or cubic.
50 - 60 mm/s print speed.
35 mm/s infill speed.
35 mm/s outer wall speed.
45 mm/s inner wall speed.
160 mm/s travel speed.
Support Everywhere for best threads support
Support Pattern Lines
Support Density 10%
Please Rate, and post makes. Lets me know posting my models is appreciated , and motivates me to post even super simple designs like this to save someone else the time of having to design it.