MK3 LCD Mount - Swivel + Low Profile

MK3 Style LCD Mount

Features:

• Low Profile 
• 90 degree full rotation
• Cable support, prevents binding
• Cable underneath for a clean look

Parts List:

• 2x M3 x 12-20mm SHCS (reuse from original mounts to frame)
• 2x M3 Square nuts (reuse from original mounts to frame)
• 2x #8 x 1 ¼" Screws - or similar

Print instructions:

• Print all parts in default orientation
• Print 2x RH-LH-Standoff
• LCD should not fall in horizontal position without any scaling. 
  • Too loose:
    • scale "RH-LH-Standoff" slightly up in XY plane, if still too loose scale down in Z plane
  • Too tight:
    • If standoff does not fit into Arms: scale down XY plane
    • Else: Scale up in Z plane.

Pre-assembly:

• Verify fit up of all printed parts
• Print a cable pass through for LCD connectors (make sure connectors fit though it!)
• Unplug printer and then connectors from LCD
• Remove all zipties holding LCD connectors except inside of Einsy Board Box
• Mark hole location where LCD connectors will reach desired mounting location (preferably directly under Einsy Board where LCD connectors exit)
• Drill hole for cable pass through

Disassembly

• Unplug printer and then connectors from LCD
• Remove LCD from printer (save screws and embedded nuts)
• Remove button knob
• Remove 2 screws in bottom of LCD, cover should now come off
• Remove arms by sliding to the sides

Assembly

• Embed nuts into new arms
• Slide new arms onto LCD (in correct orientation, RH is right if looking at LCD)
• Bolt cover back on 
• Holding "LCD-Mount" between arms, with thru hole lining up with connectors, press standoff through and screw in with M3 screw
• Repeat screw and standoff for other arm
• Plug in LCD connectors (routed though lack table)
• Align mount so bottom connecter hole is fully clear of table, and connectors comfortably reach, in all swivel orientations
• Mark hole locations for #8 screws 
• Screw into lack table using #8 screws, predrill if needed