MMU3 / MMU2S 5 Spools auto rewinder adapter for (un)original Prusa drybox / Repbox
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
5 Spools rewinder adapter for MMU2S / MMU3 in (un)original Prusa drybox or Repbox. Could be used without drybox
- Rating
- 4.952 / 5
- Likes
- 971
- Downloads
- 3,304
- Makes
- 139
- Views
- 28,861
- Reviews
- 125
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an upgrade for users of MMU and who has (un)original drybox (also works with the Slim version). This system replaces the filament buffers.
It's a project in development that I try to improve with the time, thanks for your understanding.
And thanks for your support 😉
I thinking this project to be the most useful possible :
- Easy access for changing your spools
- Auto rewinder because it's a most elegants solution than the buffer (personal opinion 😉)
- Shorty path as possible to avoid a maximum of friction
- Preservation of the opening from above for mmu maintenance

- Beam A1 mod and Beam A2 mod :
Those parts replace back parts Bean A1 A2 on the (un)original drybox.

- There are 5 spool with auto-rewinding remix (Original by Jim Nangano )
- New guide ptfe in the drybox systeme (made by myself)

PTFE connector for MMU3 owner :

For my full MMU systeme (with the two link in the bottom) you need some PTFE tubes :
The MMU3 come with (10 X 60 cm PTFE) tubes so I created this connector for use them, the clips used for maintain the ptfe tubes come also with the MMU3.

If you don't use a MMU3 kit you need about 4 meters ID=2,5mm OD=4mm : (These size are with a slack )
- 2 X 85 cm
- 2 X 80 cm
- 1 X 70 cm
I advice to buy 5 meters to be sure and cut off the excess once installed.
You needed some non printable parts :
- screw M3x10 X20
- 608 bearings X10
Be careful to build correctly your rewinder, the axle must be placed last. Put it in starting by the lid like on the bottom photo. ( thanks to @HonzaJaros_1717380 for help with this issue)


All parts were printed with PETG Prusament during testing.
Print the rewinder system in ASA if you use the heater for (un)original drybox.
I also do a fixation for the (un)original drybox on the Prusa enclosure :
https://www.printables.com/model/702384-fixation-for-unoriginal-prusa-drybox-on-the-prusa-
Fixation for Core One :
https://www.printables.com/model/1375957-unoriginal-holder-for-core-one
Pass Ptfe on the top of enclosure :
https://www.printables.com/model/702362-guide-ptfe-mmu-top-on-prusa-enclosure
You can look at this complet guide created by FuseFox Design to build the system:
https://www.printables.com/model/1126694-fusebox-build-guide-mk4s-wmmu3