1 / 3
Paper towel holder for Original Prusa Enclosure — image 1
1 / 3

Paper towel holder for Original Prusa Enclosure

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

You alway's loose your paper towel roll when you want to clean your printbed? this remix keeps it close to your printer!

Rating
5 / 5
Likes
9
Downloads
45
Makes
1
Views
366
Reviews
1

Updated at source:

Model information

Category
Accessories
License
GNU General Public License v2.0

This 2-part print gives you a place to hang your paper towel roll onto.
When i'm about to clean my printbed it's alway's in the same spot instead of half unrolled on the table next to it.

Max paper towel roll size, 31cm long/height, 13cm Ø total toll diameter, and at least 3.15cm center hole section to fit over the end-stop.

Can be mirrored for the right-handed side of the Original Prusa Enclosure.

My setup i'd use for this item:
- 0.6mm nozzle
- 4 perimeters
- 4 top and 4 bottom solid layers
- 15% gyroid infill
- 0.32mm layer height
- Supports on build plate ON (Organic support, did anti-paint the screw holes)
- 2 square connectors used to stability when glue-ing the parts together)
- Every other setting is the stock Prusament PETG setting in 0.6mm nozzle config

Printing oriëntation that i used: cut in the middle of arm holder, putting them with the higher parts upwards, with supports when it's an angled cut. (As seen on the 3rd photo/screenshot)
 

Version 2:
- Changed the model construction, The mounting part can now be printed right side up, and did cut off a fair piece of that area, to save on weight and materials.
- Decreased length of the arm, towel rolls up to 27,8cm maximum, but the print does now fit onto the Prusa XL as 1 whole.

Tags