Mounting Bracket for Drok Power Supply
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting bracket for Drok universal power supplies from Amazon. Adaptable to unistrut, extrusion, or direct wall mount.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mountable bracket for the Drok 24v 20 Amp power supply found on Amazon. The power supply can be mounted at either orientation within the bracket. The bracket should work for any of the 215x115x50mm Drok Power Supplies but the linked one is the only one that I've tested and verified.
The mounting bracket is designed in a way that it can be mounted to aluminum extrusion, traditional unistrut, or directly wall-mounted via lag screws for studs or sheetrock inserts.
As provided, the file is at a 60 degree angle from horizontal, and it's highly recommended to print at this angle with tree supports in order to minimize the risk of layer sheering along the tabs. I recommend printing in ABS-GF for structural rigidity without conductivity.
Files include a skeletonized version to save material at the cost of rigidity and "snap-on" terminal/adjustment guards for both standard mounting and inverted as shown in the example photos. These files are oriented in a way to minimize material with supports and can be printed in your favorite non-conductive filaments and colored as desired or required by local and/or corporate requirements.